Long/Short Signal (unified)

### Bybit Long/Short ###
 
# Uncomment this to set exchange & symbol (if different from your chart/alert!)
#exchange=bybit5-testnet symbol=btcusd
 
# Uncomment this for multi accounts (and fill in your accounts)
#parallel=acc1,acc2,acc3
 
# Uncomment this to skip entry if ANY position is already open
#ifpos=abort
 
# Close open positions on the opposite side at market
# ..if no matching position is found, skip the delay and jump to main order
close=[!side] type=market ifnone=main
# Give closing order time to execute
delay=2s
 
# Place main position order at market
# error abort : Abort/skip rest on error (after retries)
# retries 3   : Give up after 3 retries in case of overload
:main
cancel # cancel any open order/stop first
[side]=YOUR_BUY_IN% leverage=YOUR_LEVERAGE type=market error=abort retries=3 #notify=discord:1 
# Give main order time to execute
delay=2s
 
# Add market stop loss order
# expect 1        : Expect to place an order (needed in case main order takes longer to fill)
# error closeside : If we cannot place SL, cancel orders, close position & abort
close=[side] stoploss=[-]YOUR_STOP_LOSS% type=market expect=1 error=closeside retries=10 id=SL #notify=discord:"`SL at   \z` {stop}" 
# Add limit take profit (reduce/close only) order
close=[side] price=[+]YOUR_TAKE_PROFIT% priceref=pos expect=1 error=closeside retries=10 id=TP #notify=discord:"`TP at   \z` {price}" 

Quantity, leverage, stoploss and takeprofit have to be adjusted to your strategy / personal needs!

# switch to 10x isolated margin (on USDT Perpetual will only change leverage of that side) and place market long order using 25% available balance 
long=25% leverage=10 mt=isolated type=market
 
# switch to 10x cross margin and place market long order using 25% available balance 
long=25% leverage=10 mt=crossed type=market
 
# switch to 20x isolated margin & hedging mode and place market long order using 25% available balance 
long=25% leverage=20 mt=isolated pm=hedge type=market


Attention

Always double check that you are using the right syntax/alert!